How do I configure NAT mode for my Scanner Appliance?

Configuring a Scanner Appliance for NAT mode is required if the Scanner Appliance is connecting to the core system on a different IP (e.g NAT) than what the core system is configured to listen on in its network configuration. If the SSH endpoint is not set, the primary IP of the core is used.

To configure NAT, the SSH endpoint needs to be set with the IP which the scanner appliance can use to reach the core system. The other endpoints are also using the NAT IP of the core.

Example:

Zone A
Core system IP: 192.168.1.10

Zone B
Scanner appliance IP: 10.1.1.15
Core system IP: 10.1.1.10 (which is NAT to 192.168.1.10)
SSH endpoint will be set to: 10.1.1.10